GB
10-Installation
25
10.1 Preparation
▶
Take the appliance out of the packaging.
▶
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port
-
hole. This normal phenomenon results from water tests in the factory.
10.3 Remove the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1.
Remove the back cover (Fig. 10-3.1).
2.
Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-3.2).
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen
-
tally friendly manner.
10.2. OPTIONAL: Adjusting the bottom cover
board
-
cium-plastic board (A) The board is used for reducing
noise after covering the bottom of the cabinet.
2.
Lay the washing machine down to its side, port
-
hole pointing upwards, bottom side towards op-
erator and unscrew the four feet.
3.
Place the calcium-plastic board.
Screw the feet through the four holes on the
upright again.
A
B
1.
2.
3.
10.2
Only Model HW80-/HW100:
The felt is pointing inside the appliance.
Only Model HW80-/HW100:
There is also a felt (B) in the package.
1.
Past the felt on one side of the plastic board
(Fig. 10.2).
A
10-3.1
10-3.2
WARNING!
The washing machine is heavy u-
se appropriate lifting methods w-
hen fitting the bottom cover.
