GB
6-Daily use
17
1. At programme cycle end
END
is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
To interrupt a running programme press gently “Start/Pause“. The LED in the button is
fl
ashing. Press it again to resume operation.
To cancel a running programme and all its individual settings
1.
Press “Start/Pause” button to interrupt the running programme.
2.
3.
4.
Select a new programme and start it.
6.12 After washing
Note: Door lock
▶
For safety reasons the door is locked during the washing cycle. It is only possible to
open the door at the end of the programme or after the programme was cancelled
correctly (see description above).
▶
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door;
Loc
1
-
is displayed
Note: Standby mode / energy-saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
This saves energy. To interrupt the standby mode push “Start/Pause“ button.
6.10 Start wash programme
Press “Start/Pause“ button (Fig. 6-10) to start. Appli
-
ance operates according to present settings. Changes
are only possible by cancelling the programme.
6.11 Interrupt - cancel wash programme
Start/
Pause
6-10
6.13 Activate or deactivate the buzzer
The acoustic signal can be deselected if necessary:
1. Switch on the appliance.
2. Select the SPIN programme.
3. Press the “Delay “button and “Spin speed” button at the same time for about 3 sec-
onds. “
bEEP OFF
” will be displayed and the buzzer will be deactivated.
For activating the buzzer press these two buttons at the same time again. “
bEEP
ON
”
will be displayed
