To install the SW12, neutral and phase are required at the in-
stallation point.
• Take the wall switch out of the wall box.
• Disconnect all wires from the switch.
• Connect the live to the terminal wire L (3, Live) of the SW12
and to the switch as described in the drawing.
• Connect the neutral to the N (2, Neutral) terminal wire of the
SW12 and to the Neutral of the Motor.
• Connect the DN (1) terminal of SW12 to Motor Down, the UP
(4) terminal to Motor Up.
• Connect the Blue (5) wire coming from the SW12 to the Up
key of the switch, the Orange (6) wire from the SW12 to the
Down key of the switch.
• Put the SW12 into the wall box and re-fix the wall switch on
the wall box.
• Switch on mains fuse and master switch.
PROGRAMMING
Before the unit can be used it has to be told what the window
height is. This means it needs to know how long it takes to
travel from fully open to fully closed. It also needs to know
where the current position of the blind is - whether fully up or
down or at some intermediate position. To enter this data into
the unit and also to set in the X-10 address the unit must be
put into Install Mode.
To enter Install Mode:
Press the UP key. The blind will travel up until it reaches the top
end stop. Continue to press the key and 5 seconds after reach-
ing the fully up position it will enter Install Mode. At this point it
9
SW12
