onds before returning to the fully down position to indicate it
has left Install Mode. The unit will also return to RUN mode if
no keys are pressed for 1 minute.
DEFAULT SETTING
When the unit leaves the factory the window size will be set to
Maximum (2 mins. and 8 sec) and the Blind’s position will be
set to Fully Up. This makes it particularly easy to get into Install
Mode because the 5 second timeout on the UP key will then
start immediately it is pressed. If the window size and the
blind’s position is unknown, however, it might seem confusing
when first trying to enter Install Mode since the user will not
know how long it will take to get to the fully up position before
starting to count the 5 second entry delay into Install.
To make it easier the unit can be put into the default setting im-
mediately by doing the following procedure.
-
Remove power to the unit and wait 10 seconds.
-
Re-apply power and within 1 minute send ‘P16’ ‘PON’ twice.
You can also use ‘P16’ ‘POFF’ if you wish.
-
The unit will now set in the default setting described above
and will set the unit’s address to P16 without the need to get
into Install Mode.
You can then get into Install Mode simply by pressing the UP
Key for 5 seconds or so and then entering the settings you re-
ally want to use.
11
SW12
