BRIGHT and DIM can be used to set the blind to any position.
The action is identical to that which occurs when the UP and
DOWN keys are pressed. Bright is equivalent to UP and DIM is
equivalent to DOWN.
The unit will also respond to ‘Extended’ code1 X-10 messages
of Type = 0. Using these commands enables the unit to re-
motely set the blind to any desired position using a suitable
controller and fully automate the blinds in the house, apartment
or office. Extended code messages can be sent to the SW12
using a CM15PRO Computer Interface for example.
FREQENTLY ASKED QUESTIONS
What is the reason for modules to switch on/off sponta-
neously?
It is possible that a
Haibrain
X-10 System is installed at one of
your neighbours using the same House Code. To solve this
problem try to change the House Code of your system, or have
FD10 Phase Coupler/Filter installed at your incoming mains.
My modules will not respond to my controller.
Make sure that the House Code on all Modules and Controllers
are set to the same House Code (A .. P).
My modules will not react to my remote / sensor.
When you use a remote or sensor, you should have at least one
TM13 Transceiver or
Haibrain
X-10 Security Console installed
in
your house. These components will translate the radio signals
to
the
Haibrain
X-10 signal on the power line. Using several re-
motes and sensors, you only need one central transceiver.
13
SW12
