Page 7
For internal use only
Assembly Instructions CB 280
A14
Install the lock ring for the wear ring.
A13
Heat up the wear ring to 110°C
(230°F). Install it on the shaft.
Tap it down with a plastic hammer.
A15
Gently pull back the wear ring so that the lock ring no
longer is loose.
To keep the lock ring permanent, the wear ring has to
be kept in place against the lock ring, until it is shrinked.
A16
Turn the cylinder block and install it into the shaft end
housing. Be careful not to damage the radial seal.
Use two lifting eyes M12.
