Page 6
For internal use only
Assembly Instructions CB 280
A12
Lubricate the O-ring for the wear ring with oil
and install it on the shaft.
A9
Lubricate the O-ring with oil and install it in the shaft
end housing.
Note!
The screw joint on the motor works as a frictional
connection, so no oil are allowed on the surface.
A11
Heat up the roller bearing to 110°C (230°F) in an oven.
Tap the bearing down with a brass or a plastic rod. The
bearing should be turned according to drawing A10.
Note!
To awoid damages on the bearing only tap on the
inner race of the bearing.
A10
Note!
The snap ring on the bearing shall be towards
the middle of the motor.
Position of
the snap ring
