Page 12
For internal use only
Assembly Instructions CB 280
A33
Lubricate the surface on the cylinder block with oil.
A34
Turn over the connection block and lift it on the top of
the motor. Use two lifting eyes M12. The roll pin holes
should correspond to the threaded holes in the shaft
end housing.
Note!
Make sure that the surfaces between the cam
ring and connection block are absolutely clean.
Important!
Place the
lifting
arrangement
on the top
A36
Place the plugs at their places, to avoid that dirt comes
into the motor.
A35
Lubricate the threads and
tighten four screws firmly,
then open them half a turn
(90 degrees) or until it is loose.
