Assembly
28
Technical changes reserved
Installation on an existing wall (with/without cooling cable duct)
1 Additional rear panel
2 Fire safety housing
3 Existing wall
4 Securing bracket to prevent tilt-
ing
5 Cooling cable duct
Step
Action
1
-
Attach the additional rear panel (1) to the fire safety housing as described
above.
-
Position and align the housing (2) against the existing wall (3)
2
-
Drill pilot holes through the securing
bracket (5)
-
Fasten the securing bracket (6) to the
additional rear panel using flat headed
screws 4.5 x 35 mm and the supplied
washer
3
Install the securing bracket at an external
depth of d < 600 mm:
-
Screw the securing brackets to prevent
tilting (4) to the left/right side of the
housing using flat headed screws
4.5 x 35 mm
-
Anchor to the floor using dowels (7)
