8
ensure the connection is watertight
and dust proof. A cord with a proper
rating should be used. A cord rated
for less amperes or watts than the
appliance rating may overheat. Care
should be taken to arrange the cord
so that it will not be tripped over or
pulled. The connection should
be carried out by a qualified
electrical installer.
10.
Ensure that the appliance is placed on
a flat, even surface.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
Only close adherence of these
installation, electrical and maintenance
guidelines will ensure the safe and
efficient use of this appliance.
EXO TERRA
®
600W DIMMING & PULSE PROPORTIONAL THERMOSTAT
INSTALLATION INSTRUCTIONS
INSTALLATION in Exo Terra
®
Natural Terrariums
Follow this installation procedure to install the
Exo Terra
®
Thermostat
on any size of Exo Terra
®
Natural Terrarium:
1.
Unlock the top screen cover and lift it off the terrarium.
2.
Slide one of the inlet holes (located on the back of the screen top
on either side) to the open position, so the wiring will fit through.
3.
Feed the wire with sensor through the first available inlet hole on
the preferred side on the back of the screen cover.
4.
Position the sensor inside your terrarium, in the location where you
want to reach the temperature set on the Blue LCD Screen. This
can be on top of the substrate if you are using a Heat Mat or Heat
Cable, but this can also be on a branch, cave or pile of stones if
you are using a Ceramic Heater or Heat Bulb to heat up a certain
basking area.
5.
Place the top screen cover back on the terrarium and lock it
into position.
