Manual RDS B-in-Radio 12V
Fitting to
833.02.820
Version (modifications reseverd)
17.08.2015
Seite 14 von 15
12.3. Frequency setting of radio stations
Radio station frequency settings via tuning (SCAN)
Press the button „
SCAN
“
The scan begins at 87,5 MHz and stops automatically at the first found active radio station frequency.
The scan can be continued by pressing the button „
SCAN
“ again.
Adding the found frequency to your selected radio stations press the button „
MEM
“, then chose your
memory space button (
1-9
).
Manual radio station frequency setting (Frequenz)
Press the button „
FREQ
“
Tap in your preferred frequency by pressing the buttons (
1-9
), e.g. 97,8
Confirm your setting by pressing the button „
FREQ
“
Adding the frequency to your selected radio stations press the button „
MEM
“, then chose your memory
space button (
1-9 / e.g. # 2
).
Automatic assignment of the channel positions
The radio channels 1-9 can be assigned automatically.
Press the button „
MEM
“ and then the button „
SCAN
“
Note:
The scan may take a few minutes. Be patient.
Parameters are saved automatically
The station selection and volume settings are saved automatically every 10 seconds.
12.4. Changing battery
- Gently pull and slide the battery compartment
tray as shown
- Remove old battery making note of the polarity
positions
- Insert NEW replacement battery
- Close battery insert
Attention:
Only use suitable batteries of type
Lithium 3V CR 2025
