Häfele HH-VR603T, Инструкция по использованию и установке

Страница: 11 / 27

11
Dual-circuit cut-off
▪ The dual-circuits are immediately connected upon activating a respective cooking
zone(C).
▪ By pressing the key (F) of an activated cooking zone (cooking stage level ≠ "O") the
corresponding outer circuit of the respective cooking zone can be cut oH any time.
An activated outer circuit is displayed by an additional LED (G).
▪ Pressing the key (F) again connects the outer circuit/s any time, the respective LED's
flash up again.
Warming Function
The warming function is used to keep cooked food warm.
Activating heating function:
• Touch the sensor (F) to select the desired hotplate.
•
Selected hotplate must be set to level “0”.
• Pressing the sensor (C), then the sensor (E) to activate the “melting” function;an (u) will
be shown in the display.
If the sensor (C) or (E) is pressed again, heating function deactivates.
Timer
Timer facilitates the cooking procedure by setting the period of hotplate operation, and
it can also be used as alarm timer.
Activating the timer
• Cooking zone must be on and working.
• Touch the sensor (F) of the relevant hotplate.
• By touching the (C) or (E) sensor select the power setting from 1 to 9.
• Touch the sensors (E) and (C) simultaneously to activate timer. Timer display (H)
indicates »00.«, (I) is flashing.
• Within 10 seconds, touch sensor (C) or (E) to set the desired cooking time (from 01 to
99 minutes). After a few seconds timer starts operating. Timer controlled hotplate
control lamp (I) is on (flashing or steady).
You can use timer to set exact cooking time for each hotplate at the same time.
To speed up the timer setting keep the relevant sensors (C) or (E) constantly
pressed.
Altering preset cooking time
• You can change preset cooking time whenever you wish during the hotplate
operation.
• Touch the sensor (F) to select the desired hotplate.
• Touch the sensors (C) and (E) simultaneously to activate the timer, (I) of the selected
hotplate is flashing.
• By touching sensors (C) or (E) set the new desired cooking time.
Remaining cooking time
You can display the remaining cooking time:
• by touching the sensor (F). The cooking zone, which has the lowest value, indicates
this with a flashing decimal point (I).
• By pressing the sensors (C) and (E) at the same time; time shown in timer’s display
correspondes to the zone where (I) or (L) flashes.
Switching the timer off
When the preset time expires a beep is heard which you can either turn off by touching
any sensor or leave it to turn off automatically after 2 minutes and turns off cooking
zone too.
Switching the timer of prior expiry of preset time:
• Touch the sensor (F) to select the desired hotplate.
• Touch sensors (E) and (C) simultaneously.
• By touching the sensor (E) set cooking time to »00.«. Timer function is off, but the
hotplate continues to operate until you switch it off manually.
Fast switch off
• Touch the sensor (F) to select the desired hotplate.
• Simultaneously touch both (G) and (E) sensors.
• Timer display (H) turn off and the hotplate indicator displays »0«.