Hafco TS250SC, Инструкция по эксплуатации

Страница: 9 / 28

B
6.2 Installing the front rail
Install the front rail needs following
hardwares:
4-M8x25 mm cross cylinder head screws
4-8 mm
ß at washer
4-M8 mm hex self-lock nuts
1, Take out the front rail from the master case.
2, Align the front rail onto the front edge of table.
(Figure 9)
6
Figure 10
Figure 9
3, Put 4-M8x25 mm cross cylinder head
screws into the holes on the front rail.
(Figure 10)
4, Under table, loosely attach the
ß at washers
and nuts onto screws.
5, Align the front rail parallel to the table then
tighten all screws.
6.3 Installing the Rear Extension Table
Install the rear rail needs following
hardware:
2-M8x25 mm Hex Head Bolt
2-M8 mm Nut
2-M8 mm Washer
2-M6x12 mm Grub Screw
3mm Allen Wrench
1, Take out the rear extension table from the
master case.
2, Align the rear extension table onto the rear
edge of major table.
3, Connect the rear extension table and the
major table by two M8x25 mm hex head bolts
and fasten the bolts by 8mm Wrench (A).
(Figure 11)
4, Use 3mm Allen Wrench to djust 2-M6x12 mm
grub screws (B), to adjust the
ß atness of the
rear extension table and the major table.
Figure 11
A B
6.4 Installing the rip fence
1, Take out the rip fence part from the master
case.
2, Fit the handle (A) into the fence head (B) and
turn clockwise to lock it. (Figure 12)
3, Assemble the lens (C) to the fence head (B)
by a Pan Head Screw M4x10 mm.
Figure 12
A
C