Hafco TS250SC, Инструкция по эксплуатации

Страница: 8 / 28

5
Miter gage
•
The miter gage is used in making cross cuts in
the workpiece.
•
Adjust the angle (Figure 7)
1, Loosen the knurled nut and the shorter lock
knob
2, Keep the longer lock knob by hand and turn
the locking handle counterclockwise.
3, Move the miter gage base to the desired
angle.
4, Securely tighten all the above loosened parts.
•
Lock the miter gage on the work table
1, Loosen the knurled nut
2, Keep the locking handle by hand and turn the
longer lock knob clockwise
•
Quick release
1, Push the quick release to move the hold
down clamp onto the workpiece quickly.
2, Turn the clamp knob and fasten the
workpiece
3, To prevent the use of the quick release, roll
the quick release stop around to the top of
the quick release.
Figure 7
Figure 6
Caution:
This table saw is shipped in two packages: the
master case and the sliding carriage carton.
Warning!
Do not lift the saw unit without help.
The saw unit weighs approximately 145 kgs.
Hold it close to your body. Keep your knees
bent and lift with your legs, not your back.
Ignoring these precautions can result in back
injury.
6.1 Installing side extension table
•
Unpacking the master case. Take away the
case panels and take out the main unit of the
table saw from the pallet.
1, At the right side of major table, put 4-M8x30
hex head screws with 8 mm washer in holes,
so the screw heads extend outward 10mm.
Warning:
The table weights approximately 28 kgs.
Installing extension table needs another-man’s
help.
2, Take out the right extension table from the
cardboard box in the master case. Lift it
slightly and put in onto the 4 screws. Make
sure the four “U” shape slots be up on the
screws.
3, Center the extension table over the edges
and tap it. Check the surface alignment.
(Figure 8)
4, Tighten 4-screws with a 12mm wrench.
Figure 8
6. Initial Operation