Hafco TS250SC, Инструкция по эксплуатации, Страница: 13 / 28

7. Operation
Risk of injury!
• This machine may only be operated by one
person at a time. Other persons may stay only
at a distance from the saw for the purpose of
feeding or removing stock.
• Before starting workoring, check to see that
the followings are in proper working order:
- power cable and plug;
- ON/OFF switch;
- riving knife;
- blade guard;
- push stick.
• Use personal protection gear:
- dust respirator;
- hearing protection;
- safety goggles.
• Assume proper operating position:
- at the front of the saw;
- in front of the saw;
- to the left of the line of cut.
- If working with two persons the second person
should stand at a rear table extension.
• In case of the type of work requires, use the
followings:
- table extension if working with two persons or
if otherwise workpieces would fall off the saw
table;
- dust collector.
• Avoid typical operator mistakes:
- Do not attempt to stop the saw blade by
pushing the workpiece against its side.
Risk
of kickback
.
- Always hold the workpiece down on the table
and do not jam it.
Risk of kickback
.
Drawing-in/trapping hazard!
• Never cut stock to which ropes, cords, strings,
cables or wires are attached or which contain
such materials.
- Never cut several workpieces at the same
time – and also no bundles containing several
individual pieces.
• Risk of personal injury if individual pieces are
caught by the saw blade uncontrolled.
9, Place the Miter Gauge on the major table,
with the miter gauge rod on the T-slot of the
major table. (Figure 25)
A
B
Figure 24
Figure 25
6.9 Mains Connection
Danger! Electrical Hazard!
• Operate the machine in dry environment only.
• Operate the machine only on a power source
matching the following requirements:
- mains voltage and system frequency conform
to the voltage and frequency shown on the
saw’s name plate;
- outlets properly installed, earthed and tested,
• Position power supply cable so it does not
interfere with the work and is not damaged.
• Protect power supply cable from heat,
aggressive liquids and sharp edges.
• Do not pull on power supply cable to unplug.
10