Hafco TS250SC, Инструкция по эксплуатации

Страница: 11 / 28

8
Caution!
In order for the saw dust to be effectively led off
the chip ejection tube supplied has to be
installed even if no dust collector is hooked up.
The chip ejection tube shall not be blocked by
other objects.
6.8 Installing the sliding carriage
1, Unpack the sliding carriage carton. Take out
the sliding carriage slightly. Take care and
keep well the loose parts inside the foam.
Take away the foam in a certain place.
2, Place the sliding carriage onto the two
supports (A) on the left side of the saw unit,
with the square guide piece (B) inserting on
the T-Slot of the bottom of the sliding carriage.
(Figure 16)
Fasten the Knurled Screws (C) tightly.
(Figure 17)
Warning!
Do Not lift the sliding carriage without help.
The length is approx. 1.70 m, while it weighs
approx. 25 kgs. Seek for other man’s help to
avoid unforeseen injury.
Figure 16
B
A
Be sure the safety switch is placed in the
correct position (Hole A) of the sliding carriage.
(Figure 18 - 1) Otherwise the machine can not
be switched on.
C
Figure 17
Figure 18 - 1
Safety Switch
Hole A
3, Assemble the lock handle (A) to the sliding
carriage by by 1-M12 Nut. (Figure 19)
Assembly the sliding carriage handle by
inserting the square nut into the T-Slot of the
sliding carriage. Turn colockwise to
Þ x it.
(Fugure 20)
Figure 19
A
M12 Nut
Handle
Square Nut
Figure 20
Limiting Screw
Support Plate
Sliding Carriage
Safety Switch
Be sure to position the limiting screw next to
the support plate. It will help to correctly position
the sliding carriage. (Figure 18 - 2)
Figure 18 - 2
The safety switch may ensure the machine
not to run in case of the sliding carriage moving
away and may prevent people from been injured
by the saw blade.