Fitting lower dust chute
Fit the lower dust chute plate and extraction port
The plate has 2 tabs these sit in the top side slots of the
dust chute and then slide plate up.
Fit the plastic extraction cute over the bottom and secure
both with the
2off M5 x 10 hex head bolts
supplied
Table adjustment
# Check table slides are adjusted correctly
There are 2 slide keys. One on each table.
These allow the table to be set flat
to each other and to stop the infeed
table falling down by itself during
use.
They adjustment screws (
4
off) need to be set.
Firstly undo the locking nut on the screw. Then turn
the screw all the way in and undo ¼ of a turn. Lock the
nut Test table still moves freely.
The infeed table should not be too loose as it will fall
lower during operation if it is.
# Connect a dust extractor
# Your machine is now ready to use.
M5 x 10mm
hex head bolt
Adjustment screw
and lock nut
page 13
