Setting
Vee belt and guarding
# Using a straight edge or by sighting up from the top, line up
the spindle and Motor pulley by sliding both or either along
their
shafts.
When this is done ensure both grub
screws are tightened to hold pulleys on
firmly
# Fit the vee belt onto the two pulleys and tighten the 4 x motor mount bolts ensuring the
motor is in line with the spindle and not twisted.
Set vee belt tension so that moderate finger pressure on the middle of the vee belt can
push it in 12mm
# Fit the upper vee belt guard using 2 x large
head Phillips head dome screws and washers
Fit the lower outer cover using 4 x M5
x
2
0mm long
Phillips head dome
screws
and washers supplied
Fit the rear lower vee belt guard with 4 x M4 x
8 long
Phillips head dome
screws
Looking down from top, swing the guard
assembly left or right so the motor shaft is
sitting in the middle of the slot of the lover
rear guard.
Tighten all screws
Motor pulley fitted
with hub out!
Using a straight edge to
line up pulleys
Page 9
