Hafco Metalmaster HM-32B, Инструкция по эксплуатации, Страница: 9 / 23

Fog.6
10.TO CHANGE TOOLS
(1)Removing Face Mill or Drill Chuck Arbor.
Loosen the draw bar bolt at the top of the spindle approximately 2 turns with a
wrench, Rap the top of the spindle sharply with a mallet.
After taper has been broken loose hold chuck arbor in one hand and unscrew
spindle with the other hand.
(2)To in stall Face Mill or Cutter Arbor
Insert cutter and cutter arbor into the taper of spindle. Tighten arbor bolt
securely.but do not overtighten.
(3)Removing taper Drills
(a)Turn down the arbor bolt and insert the taper drill into the spindle shaft.
(b)Turn the rapid down handle rod down nutil the oblong in the rack gera
sleeve appears, line up this hole with the hole in the spindle. Insert Key through
holes and strike lightly with a mallet.This will force the taper drill out.