Esento-RDU Installation, Commissioning & Operating Manual
Approved Document Ref: DOC00636 Issue 4.0
14
SETUP & PROGRAMMING
1
. View Active Disablements
Press the ENTER button and all active zone, sounder circuit or delay disablements on the entire
network will be displayed. Use the scroll buttons to view the disablements.
The display will time out automatically or holding button 1 for 3 seconds
will take you
back to the user menu.
2
. Set Time & Date
1. Set Clock -
Press the ENTER button to access the clock setting mode. Use the scroll buttons
to alter the values and the ENTER button to move on to the next value. The final ENTER will set
the value to all repeaters on the network and return to the Set Time & Date menu. If a mistake is
made the only option is to go around the setting process again.
2. Set Daylight Savings -
Press the ENTER button to access the daylight saving setting mode.
Use the scroll buttons to alter the start or end dates and the ENTER button to move to the next
value. Press ENTER again to select daylight saving ON or OFF and use the scroll buttons to
change the setting. The final ENTER will set the value to all repeaters on the network and return
to the Set Time & Date menu.
3. Go Back -
Return to previous menu. (Holding button 1 for 3 seconds at any time will also save the
settings and return to the previous menu).
3
. Configure Repeater
(Note: these repeater configurations, including names, are only entered for
the local repeater. If using multiple repeaters each must be programmed seperately).
1. Edit Company Name -
Press the ENTER button to access the Company Name edit mode.
Use the scroll buttons to move the characters through the lists and press the ENTER button to
move to the next character along. Buttons 1 & 3 also navigate forwards & backwards along the
line.
Button 4 changes the character lists between upper case and lower case letters, numbers and symbols.
40 characters are available for name, phone number etc. When completed hold button 1 for 3 seconds
to save settings and return to the Configuration Menu.
2. Edit Panel Names -
If the system contains networked control panels the RDU can be programmed to
display a different name for each of the panels on the network rather than Panel 1, Panel 2 etc. Press the
ENTER button to access the Edit Panel Names mode. Up to 8 panel names are available, 1 is the master
panel and 2-8 are the network slave panels (in panel address sequence). Use the scroll buttons
to select the panel and press the ENTER button to edit the panel name. Use the scroll buttons to
move the characters through the lists and press the ENTER button to move to the next character
along. Buttons 1 & 3 also navigate forwards & backwards along the line.
Button 4 changes the character lists between upper case and lower case letters, numbers and
symbols. Up to 16 characters are available. When completed hold button 1 for 3 seconds
to
save settings and return to the Configuration Menu.
Scroll up
Scroll down
Scroll up
Scroll down
Scroll up
Scroll down
Scroll up
Scroll down
Scroll up
Scroll down
Содержание ESENTO XL-RDU
Страница 24: ...www haes systems co uk ...
