Haes ESENTO XL-RDU, Инструкция по установке, пусконаладке и эксплуатации

Страница: 13 / 24

Esento-RDU Installation, Commissioning & Operating Manual Approved Document Ref: DOC00636 Issue 4.0
11
SETUP & PROGRAMMING
With the zone 6 fire LED lit, the amber, fault LEDs will show the current setting.
LED 1 OFF = fault tolerant monitoring (default). LED 1 ON = legacy, radial circuit monitoring.
Press the ENTER button, zone 6 fire LED will pulse to indicate ‘edit mode’.
Now use button 2 to change the setting (LED 1 ON or OFF).
When finished press the ENTER button again and the zone 6 fire LED will return to steady ‘view mode’.
Press button 1 for 3 seconds to exit programming mode 2-1-2-3.
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
2 1 2 3
Panel Wide Settings
There are 11 general, panel wide, settings available.
Enter the above code and press the ENTER button. The 11 programmable
options are represented by fire zone LEDs 1 - 11, Option 6 being the,
‘change repeater comms monitoring type’ setting.
Use button 1 to move to option 6
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
RESOUND SILENCE RESET
ENTER
1 2 3 4
Disable
Mode
Test
Mode
Mute
Buzzer
Test
Lamps
Fire LED Programming Option
1
2
3
4
5
6 Change network/repeater comms monitoring type
OPTION 6.
Change Network/Repeater Comms Monitoring Type (EN54!)
To change the Comms monitoring type at the main control panel use: