page 3
HAEHNE
Elektronische Messgeräte GmbH · Heinrich-Hertz-Str. 29 · D-40699 Erkrath Germany · Telefon 0211/9 25 91-0 · Fax 0211/9 25 91-20
http://www.haehne.de
Email: [email protected]
HAEHNE
Sensor B does not exist
in case of single-sided
measurement
different connection
in case of explosion
proof applications
Connection / Wiring
Please refer to the "Practice Guide of Web Tension Measurement and Control" for wiring instructions
and the selection of the most suitable mounting location of the amplifier.
Very important:
Connect the shield of the sensor cable single sided on the amplifier side to protection
earth (PE) with low resistance. Connect GND separately from the shield with PE.
Additional recommendation: Connect the 0 V of the 24 V circuitry at a defined place prefably in close
proximity of the PE. If this reference point is to be operated in the "floating point" mode, then the voltage
between 0 V and PE should not exceed 50 Vpp.
The four terminal blocks with five
terminals each can be separatly
plugged in, simplifying trouble
shooting in case of faults.
V
1
Output signal of full bridge
strain gauge
V
2
Direct voltage output
V
3
Dampened voltage output
V
4
Excitation voltage to the full
bridge strain gauge in the sensors
V
5
Supply voltage 24 V DC
I
1
Current output (option C and N)
Sensor cable lead colors
green
yellow
brown
+
+
-
-
white
V
1
: bridge output signal
V
4
: bridge supply voltage
PE
GND
0V
green
white
brown
yellow
green
white
brown
yellow
field
field
PE terminal
PE terminal
08.08 DE1DM2EA.indd
+
+
-
-
+
+
-
-