The X-speed controllers have an optimal default setup for A-Motors.
Factory default settings:
Brake:
Off
Battery type all ESCs:
Li-Po
Cut off:
LiPo-Autodetect with 3,2V/cell (Pack must have more than 3,8V/cell while
connected, in other case, the ESC cannot detect the correct Nr. of cells and this may cause
a underloaded Pack)
Under voltage:
Reduce power
Acceleration :
Fast
Timing:
Auto
Frequency:
8KHz
Active RPM-Control (Helimode / Governormode):
Off
Normal start up:
When throttle stick is off, connect battery pack,switch on the controller (if switch is installed), you
will hear a number of tones which indicate the number of cells the ESC detected and two tones for
Brake off.
For changing the default setup, please read the following manual
ESC program procedure
It is possible to program the ESC in two different ways:
-by using a Computer with “Hacker X-Pro USB-Interface” and a special software, which can be
acquired, (see then enclosed operating instructions).
The USB software offers still additional adjusting parameters:
-variable cutoff voltage for LiPo cells
-Brake "off", "soft", "hard"
-finer gradations in the Motortiming
-acceleration in three stages selectable
-updates for the X-Pro ESC
-programming by throttlestick:
With throttle stick at full power, connect the battery and wait for 5 sec. Program mode is entered
when you hear two low tones and two high tones. _ _ - -
Each time you enter the programming mode you are allowed to make one change and then you
will automatically exit the programming mode. To change more than one parameter you will have
to re-enter the programming mode each time.
Attention!
LiPo-Autodetect is the factory-default-setting. It can be deactivated with throttle-stick
programming but can only activated by programming with PC-Software and USB!
1. Brake
To change the brake function, as soon as you hear the programming tones mentioned
above, move the throttle stick to low position.
Brake
function will be inverted. (IE: If brake
was on, it now will be off.)
To change any of the remaining functions, enter the programming mode as detailed above.
Leave the throttle at high position until you are within the five sets of beeps as detailed in
Copyright 06/07 – Hacker Motor GmbH 2
