H3C WA6630X, Руководство по установке

Страница: 11 / 34

2-1
2
Installing the AP
IMPORTANT:
•
To ensure radio coverage, have the AP installed by technical personnel as a best practice.
•
You can mount the AP on a pole or wall and route the cables in the pole or wall. The figures in
the following installation procedures are for illustration only.
When you install the AP, follow these restrictions and guidelines:
•
The AP is large and heavy. Avoid bodily injury and device damage during the installation.
•
If you install the AP on a pole, make sure the pole is vertical to the ground and iron
components have been treated with corrosion protection.
•
If you pole-mount the AP on the top of a building, make sure the AP does not project beyond
the sides of the building.
•
To avoid high temperature caused by exposure to the sun, install the AP in a place without or
with less direct sunlight and take protection measures if necessary.
Pre-installation tasks
Before installing an AP, perform the following tasks:
•
Connect the AP to the power source and the network. Examine the LED to verify that the AP
can operate correctly. For more information about the AP LED, see "
Appendix B LEDs and
Ports ."
•
Verify that cabling at the installation site has been completed.
•
Record the AP MAC address and serial number marked on the rear of the AP for future use.