H3C S6850 Series, Руководство по настройке

Страница: 37 / 394

8
•
Reflector port for mirroring.
•
Forcibly bringing up a fiber port.
Splitting a 100-GE interface into four 25-GE breakout interfaces
1. Enter system view.
system-view
2. Enter 100-GE interface view.
interface interface-type interface-number
3. Split the 100-GE interface into four 25-GE breakout interfaces.
using twenty-fivegige
By default, a 100-GE interface is not split and operates as a single interface.
Combining four 25-GE breakout interfaces into a 100-GE interface
1. Enter system view.
system-view
2. Enter the view of any 25-GE breakout interface.
interface interface-type interface-number
3. Combine the four 25-GE breakout interfaces into a 100-GE interface.
using hundredgige
By default, a 25-GE breakout interface operates as a single interface.
Configuring basic settings of an Ethernet interface
About Ethernet interface basic settings
You can configure an Ethernet interface to operate in one of the following duplex modes:
•
Full-duplex mode —The interface can send and receive packets simultaneously.
•
Half-duplex mode —The interface can only send or receive packets at a given time.
•
Autonegotiation mode —The interface negotiates a duplex mode with its peer.
You can set the speed of an Ethernet interface or enable it to automatically negotiate a speed with its
peer.
Restrictions and guidelines
The
shutdown
and
port up-mode
commands are mutually exclusive.
The
shutdown
command cannot be configured on an Ethernet interface in a loopback test.
Procedure
1. Enter system view.
system-view
2. Enter Ethernet interface view.
interface interface-type interface-number
3. Set the description for the Ethernet interface.
description text
The default setting is interface-name Interface . For example, Twenty-FiveGigE1/0/1
Interface .
4. Set the duplex mode for the Ethernet interface.
duplex { auto | full | half }