76
GTS and line rate configuration commands
NOTE:
The Layer 3 Ethernet interface in this chapter refers to the Ethernet port that can perform IP routing and
inter-VLAN routing. You can set an Ethernet port as a Layer 3 Ethernet interface by using the
port
link-mode
route
command (see the
Layer 2—LAN Switching Configuration Guide).
GTS configuration commands
display qos gts interface
Syntax
display qos gts interface
[
interface-type interface-number
] [
|
{
begin
|
exclude
|
include
}
regular-expression
]
View
Any view
Default level
1: Monitor level
Parameters
interface-type interface-number
: Specifies an interface by its type and number.
|
: Filters command output by specifying a regular expression. For more information about regular
expressions, see the
Fundamentals Configuration Guide
.
begin
: Displays the first line that matches the specified regular expression and all lines that follow.
exclude
: Displays all lines that do not match the specified regular expression.
include
: Displays all lines that match the specified regular expression.
regular-expression
: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the
display qos gts interface
command to view generic traffic shaping (GTS) configuration
information on a specified interface or on all the interfaces.
If no interface is specified, this command displays the GTS configuration information on all the interfaces.
Examples
# Display the GTS configuration information on all the interfaces.
<Sysname> display qos gts interface
Interface: GigabitEthernet1/0/1
Rule(s): If-match queue 2
CIR 640 (kbps), CBS 40960 (byte)
