126
View
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameters
vlan-id
: Specifies a VLAN ID, ranging from 1 to 4094. Make sure that the VLAN specified by the VLAN
ID already exists.
Description
Use the
port access vlan
command to assign the current access ports to the specified VLAN.
Use the
undo port access vlan
command to restore the default.
By default, all access ports belong to VLAN 1.
You can assign an access port to only one VLAN under the following conditions:
•
In port group view, this command applies to all ports in the port group. For more information about
port groups, see the
Layer 2—LAN Switching Configuration Guide
.
•
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and
its aggregation member ports. If the system fails to apply the configuration to the aggregate
interface, it stops applying the configuration to aggregation member ports. If the system fails to
apply the configuration to an aggregation member port, it skips the port and moves to the next
member port. For more information about Layer 2 aggregate interfaces, see the
Layer 2—LAN
Switching Configuration Guide
.
Examples
# Assign GigabitEthernet 1/0/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port access vlan 3
# Assign Layer 2 aggregate interface
Bridge-aggregation 1
and its member ports to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port access vlan 3
port hybrid pvid
Syntax
port hybrid pvid vlan
vlan-id
undo port hybrid pvid
View
Ethernet interface view, port group view, Layer 2 aggregate interface view