3-7
To install a fabric module:
1.
Place the fabric module on a workbench and remove the protection box from the connector
side of the fabric module. See
2.
Release the ejector levers by pressing the spring clips.
3.
Orient the fabric module with the side marked "Up" facing up. Hold the fabric module front
panel near the ejector levers with one hand and support the module bottom with the other.
Place the module bottom on the bottom guide rails of the chassis. Align the fabric module with
the target slot and insert it into the slot along the guide rails. See callout 1 in
Keep the module parallel to the slot to avoid touching other components in the chassis.
4.
As shown by callout 2 in
, continue to push the fabric module until the brakes on its
ejector levers touch the slot edges tightly. Simultaneously rotate the ejector levers inward until
the spring clips lock the ejector levers in place and the fabric module is completely seated in
the slot.
Figure 3-5 Removing the protection box from the fabric module (S12516R fabric module)
(1) Five screws to secure the protection box to the fabric module
(2) Loosen the captive screws
(3) Hold the protection box to disengage it from the connector side of the fabric module