Powering Up The Unit
Plug the controller A surge suppressor/uninterrupted power supply should be used to power the controller.
When power is applied to the unit, the display will flash and then it will display:
“Anderson Injectors
J+ Advanced
Version Number
Date
”
for a short time as it initializes and will then start displaying the flow (or
OFF
if there is no flow, or meter
connected to it), maximum theoretical flow limit for the current settings, and the gallons totalizer value. If
the above message is not displayed then unplug the box immediately and consult the factory for further
instructions.
Setting Up the Controller
The controller must be configured in order to work properly. Controllers ordered with a
meter from the factory should be properly configured on delivery. However, settings should
be double checked for correct configuration.
Make sure the following parameters have been programmed correctly into the controller:
•
k Factor
•
Active manifolds (outputs)
•
Gallons per Stroke for each outputs
•
Output mode for each output
•
Feed is enabled for each output
Refer to the included quick start guide below to confirm and change controller
settings.
