Mounting
Ensure the installation location has all the following:
●
Allow easy access to front panel
●
Must have access to 120 VAC power outlet.
●
Close proximity to other injector components.
●
Protect from direct spray
Mount the controller using the 4 metal tabs on the back of the controller enclosure.
Electrical Connections
Legend:
1.
External communication connector (see modbus manual)
2.
Water meter connector
3.
Output connector (1 through 8)
4.
Ground connectors
5.
Output Type Selector (Jumper 2-9) CAN DAMAGE EQUIPMENT IF SET INCORRECTLY
6.
Flowmeter Voltage (Jumper 1) DO NOT ADJUST WITHOUT CONSULTING FACTORY
7.
Modbus Terminator (Jumper 10) (see modbus manual)
8.
Power connector
Complete the following steps to connect the control box to the required components:
1.
Ensure the J+ Advanced controller is NOT connected to electricity.
2.
Open the enclosure by releasing the two latched on the right side of the controller.
Illustration 1: Output Board
