GYS DUOGYS 390-4S, Руководство пользователя

Страница: 11 / 36

3
REEL AND TORCH ASSEMBLY
• Open the door of the machine.
• Position the reel on to the support, taking care of driving pin
③
. To place a 200mm wire reel, first install
the adapter (ref. 042889) on the support.
• Adjust the reel break
④
to avoid the reel movement tangling the wire when welding stops.
Be careful not to
tighten too much !
Then tighten firmly the plastic screw
②
.
• The wire feeder uses double groove rollers
⑧
(Ø 0.8/ Ø 1 r Ø 1/ Ø 1.2). The visible diameter on the roller when
fitted is the one currently in use. For Ø 1 mm wire, use the Ø 1 groove.
• For the first use :
o
Release the fixing screw of the wire guide ⑤
o
Place the rollers, and tighten the screws ⑨ .
o
Then place the wire guide
⑦
as close as possible to the roller but without touching it, then tighten the
fixing screw.
• To select the adjustment of the drive rollers
⑥
, proceed as follows : loosen the knob fully, start the motor by
pressing the torch trigger, tighten the knob whilst pulling the trigger. Bend the wire where it comes out of the
nozzle and hold it in place to stop its progress. The setting is correct when the guide roller slides over the wire,
even when it is blocked at the end of the torch.
Common adjustment of the knob
⑥
: scale 3-4 for steel, and scale 2-3 for aluminium.
GAS COUPLING
Screw the regulator/flowmeter on the gas bottle, then plug the gas pipe on the connector
①.
To avoid gas leaks, use the collars provided in the accessories box.
CHOICE OF REELS:
Possible settings:
Wire Torch GAS
Ø 300
X
Steel
Ø 200
X
Argon +
CO2
Stainless
Steel
Ø 200 X
Ø 300
X*
Alu AG5
Ø 200 X*
Pure Argon
CONTROL PANEL:
In 2T or 4T position, 2 modes are proposed to ease the settings of the device: MANUAL or SYNERGIC.
Welding mode selection
2T
:
two-stage welding
4T: 4-stage welding
SPOT : Spot welding with adjustable spot
diameter
Wire speed selection
⑪
Wire speed regulator.
The speed varies from 1 to 22 m/minute.
SPOT potentiometer fitting
⑫
Manual Mode
⑬
In manual mode, the wire speed is determinated by
the user by adjusting the potentiometer
⑪
.
Synergic Mode
⑭
Position the potentiometer
⑪
in the middle of
the« OPTIMAL SYNERGIC » zone
In this mode, the device determines the optium wire
speed according to 3 parameters:
Voltage
Wire diameter
The power mode
It is possbile to adjust the speed wire + / -.
All manuals and user guides at all-guides.com
all-guides .com