GYS BT 2010, Перевод оригинального руководства

Страница: 9 / 32

• Error display
Result Screen display Analysis
ERROR CHARGE ERROR CHARGE
The battery exceeds 3000 CCA or the clamps are not
connected correctly. Charge the battery and re-test.
SYSTEM TESTING
1. Return to the main menu and select «SYSTEM TEST». The following screen appears:
SYSTEM TEST
x.xx V
2. Make sure all vehicle consumers are switched off (lights, air conditioning, radio etc.).
3. Start the engine. One of these three results appears:
Examples Screen display Analysis
Voltage below 9.6 V
START VOLTS
x.xxx V LOW
The starting voltage is not correct. The battery must
be replaced.
Voltage above 9.6 V
START VOLTS
x.xxx V NORMAL
The starting voltage is normal
No undulation
START VOLTS
NO UNDULATION
The starting voltage is not detected. Repeat the test.
CHARGING CIRCUIT TEST
Examples Results displayed Analysis
High starting voltage when the test is
performed with the engine at idle
ALT. VOLTS REDRES
xx.xx V UP
Check that the connections are good. If every -
thing is properly connected, replace the alterna -
tor
Normal starting voltage when the test
is performed with the engine at idle
ALT. VOLTS REDRES
xx.xx V NORMAL
No problem detected. Normal operation of the
alternator.
Low starting voltage when the test is
performed with the engine at idle
ALT. VOLTS REDRES
xx.xx V LOW
The alternator does not provide enough power to
the battery. Check the alternator belts, and make
sure the alternator is running when the engine is
running. If the belts slip or are broken, replace
them and re-test. Check the connection between
the alternator and the battery. If the connection
is bad, clean or replace the cable and re-test. If
the alternator belts and connection are in good
condition, replace the alternator.
4. Press «ENTER» to continue the test.
LOAD CIRCUIT TEST WITH CONSUMERS
1. The tester asks «SWITCH CONSUMERS ON AND PRESS ENTER». Turn on the heater to maximum (heat), high and
rear headlights. Do not switch on cyclic loads such as air conditioning or windshield wipers.
2. Run the engine at 2500 rpm for 15 seconds.
3. Press «ENTER», the undulation of the charging system appears. One of the two results is displayed :
Results found Screen display
Analysis
Normal undulation intensity
VOLTAGE REDR OK
xx.xx V NORMAL
OR
VOLTAGE REDR DEF
The diodes are working in the alterna -
tor/starter
9
BT 2010
EN
Original manual
Translation of the original manual
9