GYS BATIUM 24, Оригинальное руководство пользователя

Страница: 11 / 46

11
BATIUM 25/24
EN
Translation of the original instructions
8. The Batium starts the charge and indicates the battery state of charge as well as the charging current in
amperes (
1
p.44)
Indicator
on
Display
Step 1 :
Electrical current display.
Depending on the battery, the current can rise or fall.
«SOS Recovery»
mode
Analysis, start of the
desulfation and
recovery, battery
voltage
IUoU & IUIo
mode
Main charge.
Charging current.
Step 2 :
Equalisation (duration : 2h).
Step 3 :
Charge is finished
Floating charge.
End of charge
(IUIo).
The battery
cannot be
recovered.
Specific to the IUoU mode
Once the charge is finished, the charger is in floating mode : it can remain connected to the battery and
compensates for the self sicharge .
Specific to the IUIo mode
Nb : The batium does not switch to floating mode once the charge is over. If the battery stays connected afer the
end of charge, every 72h, the batium 25/24 performs a charging cycle to compensate for self-discharge.
Specific to «SOS Recovery» mode
• Once the battery is desulfated, the Batium resumes a regular IUoU charge.
• If it does not succeed in recovering the battery, the display shows «out»
.
9. When the battery is charge (green indicator), position the switch to « OFF ».
110. Disconnect the power supply cable.
11. Disconnect the clamps / or the battery connector.
In the event of a power cut, the BATIUM saves the state of charge (except in « SOS Recovery » mode), and re-
sumes the charge using the latest settings.
« SOS RECOVERY » FUNCTION
This mode is for deeply discharged batteries (Anomaly 2, table p.13).
After connecting the battery, the Batium analyses the battery state of health: display
.
If after 1 minute, the « SOS Recovery » indicator flashes, this means that the battery is sulfated (due to a long deep
discharge).
The « SOS Recovery » uses a specific curve to perform a 24h recovery cycle.
To activate this feature, follow these steps :
1.Disconnect the battery from the vehicle. (OVERVOLTAGE DANGER)
2.Connect the Batium to the battery.
3.Connect the Batium to the mains then position the switch to «ON».
4.Select the IUoU charging curve.
5.Activate the feature by pressing the «SOS recovery» button for 5 seconds until the indicator (p.44) switches on.
6.Choose the charging voltage and the charging speed.
7.Do not touch anything for a few seconds, the desulfation process starts.