6
GYSDUCTION AUTO
FR
Notice originale
Le Gysduction Auto peut être utilisé pour de multiples applications (suivants l’inducteur choisi) :
- décoller tous les logos, adhésifs, moulures, baguettes plastiques collées à la carrosserie.
- dégripper et débloquer les pièces métalliques (boulons, vis, bielettes...).
- déposer les vitrages collés (lunette arrière, custode, toit panoramique).
- Enlever les anti-gravillons et les joints d’étanchéité.
Le produit chauffe l’acier, mais n’est pas adapté pour chauffer l’Aluminium, le cuivre ou le zinc.
INSTRUCTIONS D’UTILISATION
2
1
3
4
6
8
9
10
7
5
1
Boutons de réglages
2
Afficheur digital
3
Indicateur de mise en marche
4
Indicateur mode Auto
5
Indicateur mode Manuel
6
Indicateur de puissance maximum
7
Bouton de sélection de mode
8
Indicateur de protection thermique
9
Zone de chauffe optimale
10
Indicateur «No load»
No-Load
En l’absence de pièce à chauffer, ou si l’inducteur est présenté sur un métal
non ferreux, l’indicateur « no-load » (10) s’allume lorsqu’une pression est
exercée sur l’une des commandes de chauffe.
Mode Automatique
Dans ce mode, le Gysduction s’adapte à la pièce qu’il chauffe (taille-épais
-
seur) et à la distance entre cette pièce et l’inducteur. Il conserve une puis
-
sance de chauffe constante et optimale symbolisée par la zone OK (9) de
l’interface. Le poste ne chauffe jamais à puissance maximale dans ce mode.
Pour entrer dans ce mode :
Le mode Automatique est le mode par défaut. Si toutefois le poste est en
mode Manuel, réaliser un appui court sur la touche MODE (7) jusqu’à ce que
la LED devant l’indication « AUTO » (4) s’allume.
Affichage : L’affichage digital montre la dernière valeur en % utilisée par la machine
pour maintenir une puissance constante et optimale selon les conditions de
chauffe. Cette valeur correspond aux réglages qu’il faudrait utiliser en mode
Manuel pour obtenir le même résultat, dans les mêmes conditions. Ainsi, si
l’utilisateur juge la chauffe préconisée par le Gysduction trop faible ou trop
forte, il peut calquer cette valeur dans le mode manuel et la faire varier à sa
guise pour atteindre la puissance désirée.
Mode Manuel
Dans ce mode, l’utilisateur sélectionne lui-même la puissance de chauffe
désirée.
Pour entrer dans ce mode : Réaliser un appui court sur la touche MODE (7) jusqu’à ce que la LED
devant l’indication « MANUAL » (5) s’allume.
Fonctionnement : L’affichage digital (2) indique le pourcentage de la puissance maximale
(2400 W) que l’inducteur peut transmettre à la pièce à chauffer. Utiliser les
boutons de réglages (1) pour régler à la puissance souhaitée.