16
GYSDUCTION AUTO
EN
Translation of the original instructions
IDENTIFICATION
On the back of the product is the following information:
• Manufacturer’s name and address
• Model
• Product serial number
• Operating voltage
• Product power
Model and serial numbermust be mentioned each time a technician intervention is required or if spare parts are
requested.
POWER SUPPLY
The GYSDUCTION is fitted with a 16A socket type CEE7/7 which must be connected to a single-phase 230V (50/60 Hz)
power supply fitted with three wires and one earthed neutral.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The product is protected for operation on a generator.
SAFETY DEVICES
• The product has the safety feature PROTEC 400. It is protected against overvoltage above 300V and against neutral
disconnection.
• During intensive use, the inductor, cables, electronics and power transformer heat up. In order to avoid dysfunction
due to overheating, the Gysduction is equipped with an air cooling circuit. A thermal protection also switches off the
product when the internal temperature becomes too high.
• The inductors are insulated to protect the user against possible electric shock..
• The Gysduction is equipped with a safety device against accidental heating. If the heating control is inadvertently
activated (pressure on the control pedal or glass inductor control button), and the inductor is not in contact with the
metal to be heated for a time exceeding one minute, then the unit will beep and switch off automatically. Release
the heater control to go back to a normal heating cycle.
PRODUCT DESCRIPTION
Gysduction is made up of an inductor connected to an alternating medium-frequency power source. When a heating
control is switched on, a strong magnetic field is emitted by the inductor. When approaching a ferrous metal, the induc
-
ted currents will create heating in the metal, without physical contact.
Gysduction Auto can be used for many applications (depending on the selected inductor):
- to remove all logos, adhesives, mouldings, plastic rods glued to bodywork.
- unbolt and unlock metal parts (bolts, screws, connecting rods...).
- remove bonded glass (rear glass, rear quarter, panoramic roof).
- Remove rubbing strips and seals.
The product will heat steel, but is not suitable for heating Aluminum, copper or zinc.
OPERATING INSTRUCTIONS
2
1
3
4
6
8
9
10
7
5
1
Setting controls
2 Digital display
3
Power-on indicator
4
Auto mode indicator
5
Manual mode indicator
6
Max. power indicator
7
Selection mode button
8
Thermal protection indicator
9
Optimal heating area
10
«No load» indicator
