11
NOMAD POWER PRO TRUCK
EN
Translation of the original instructions
Jump Start Vehicle Instruction
1. Make sure the numbers LCD Display is not less than 40%.
2. Connect the RED clamp to the vehicle’s battery positive (+) terminal and connect the BLACK clamp to the vehicle’s
battery negative (-) terminal.
3. When jump start 12 V car host displays «12V JUMP START READY», when jump start 24 V car, host displays «24V
JUMP START READY»,
4. Start the vehicle.
Do NOT Jump Start more than 3 times in a row. It could damage the unit by overheating.
Give two minutes between attempts.
The jumping cable may overheat. In this case a protection system cuts the tension at the
clamps.
5. When the vehicle is started, remove the jumper cable from Jump Starter
11
and disconnect RED and BLACK
clamps from the vehicle battery. Leave the vehicle’s engine running.
After jump start the car,don’t charge this unit immediately.
Remove the product from the vehicle battery within 30 seconds of Jump Starting. If not, it
could lead to damage.
When you can’t start the car (no jump start response), please follow the steps as below:
1. Please check whether the battery clip is connected to the car battery positive and negative pole, such as connection
error, the product doesn’t to supply power to the car battery, please confirm the connection is correct, and then try
to start again.
2. If clamps connected is correct, but still can’t start the car, please check the car battery if it is completely da-
maged (no voltage or low voltage). If it is completely damaged, please correctly choose corresponding keys, accor-
ding to the vehicle battery voltage.
-
When jumpstart 12 V Car, the host displays «12 V jump start ready». You can start the car directly. If it shows
«12 V», no any display or others on the LCD display, please disconnect the car connection wire from the posi
-
tive terminal of car battery, then use the clamps to clip on the positive and negative of car connection wire, and
press «12V» button
5
3 seconds to start, the host displays will shows «12 V jump start ready», then you can
connect the car battery and start the car again
-
When 24 V car starts, the host displays shows «24 V jump start ready». You can start the car directly. If it shows
«24 V», no any display or others on the LCD display, please disconnect the car connection wire from the positive
terminal of car battery, then use the clamps to clip on the positive and negative of car connection wire and press
«24V» button
6
3 seconds to start, the host displays will shows «24V jump start ready», then you can connect
the car battery and start the car again.
- Do not choose the wrong button, otherwise it will cause damage to cars and products, and even lead to dange-
rous situations.
3. If the above operation is still no start response, please check whether there are other troubles among the cars.
USING AS POWER SUPPLY
For Cell Phone or Tablet Instruction
1. Plug the USB cable to USB 5V output port
10
.
2. Select appropriate connector and connect it to your mobile phones or tablet.
3. Press the switch button
3
to charge.
