Gundlach 1027 Series, Руководство пользователя, Страница: 7 / 21

á
The No. 884 Universal Tile
Guide is a two-piece
assembly consisting of a
template base and a
unique detachable ruler
guide. This permits any
cutting angle between 0
and 45 , with 22 and
30 clearly designated.
The ruler guide also
doubles as a measurement
tool to accurately measure
slabs up to a foot in length.
á
The Universal Tile Guide
has a locking mechanism
that secures the ruler guide
firmly to the template base.
°
° °
°
°
° °
°
WARNING: !
Always lock the rip guide prior to transporting the saw.
1. After you have made
yourself familiar with the
components of your saw,
the machine has been
properly set up, the bucket
or water tray is filled with
water, and the electrical
connection is established in
accordance with the
relevant safety regulations,
you may now begin with the
cutting operation.
2. Before you start operation
open the water shut-off
valve.
5. After the cutting operation
is finished, prevent
accidental restarting of the
saw by pushing the
emergency stop from the
switch bracket and
unplugging the power
cable.
3. During the operation, the
user must stand in front side
of the saw, holding the
handle of the swivel-joint
cutting head with his left
hand. The workpiece must
rest on the work table and
should be pressed tightly
against the side and limit
stops with the right hand.
4. Always turn off the saw
before you leave the
machine unattended.
When cutting at constant depth
the cutting head must be pulled
against the workpiece.
1. Before you start cutting, set
the cutting head at the
desired fixed cutting depth.
2. Then use the handle to pull
the cutting head slowly and
uniformly along the guide
rail and across the
workpiece.
3. Push the cutting head fully
back after you finished the
cut.
The handling of larger cutting
depths can be simplified using
the plunge cutting method.
1. In this case, the cutting head
will not be set to a fixed
position while performing
the cut.
2. As you have not fixed the
saw at a defined depth,
Cutting at Constant Depth
Plunge Cuts
The cutting head is freely
movable during seesaw
operations.
3. Hold the handle of the
cutting head with your left
hand and move it to and fro
across the workpiece while
lightly pressing the cutting
head downwards in a
discontinuos movement.
TEMPLATE BASE
DETACHABLE RULER
THE RIP GUIDE (Optional) OPERATING THE SAW:
continued
12 11
OPERATING THE SAW