Gundlach 1027 Series, Руководство пользователя, Страница: 6 / 21

1. Remove the water pump
from the box and check
that it is not damaged.
2. Place the pump into the
bracket at the right front
corner of the water tray
along its side so that the
water outlet is positioned
horizontally. Connect the
water hose from the blade
guard to the pump and
plug the power cord into
the 3-prong receptacle.
1 . Slide the motor into the body of
the cutting head mainframe, holding
the motor front (outer) ring insert into
the mainframe bracket.
2. Holding the cutting head steady,
insert 4 bolts onto the front end of
the motor through the cutting head
mainframe. Lock the bolts tight to
hold the motor in position.
3 . Insert the inner flange onto the
blade shaft against the motor’s front
end.
4 . Place the blade onto the shaft
making sure the directional arrows
are pointing in the direction of the
shaft rotation. Secure in place with
the outer flange and blade shaft nut.
5. Insert the main long bolt in the
upright of the front plate while
holding the cutting head mainframe,
lock it tight in position. Insert the
second long bolt into the height
adjustment slot and lock it tight in
position. Place the tension spring
into position for height adjustment.
Install the side table and splash
guard as shown in the
illustration to the side. Fasten
the screws respectively to the
saw frame.
CUTTING HEAD INSTALLATION WATER PUMP INSTALLATION
10 9
SIDE TABLE & SPLASH GUARD
INSTALLATION
WARNING
: !
Disconnect the pump before attempting to handle the pump.
Never operate pump without water in the tray.
3. Fill the water tray so that
the water intake is fully
immersed.
4. Be sure to support the
pump during installation to
prevent pump failure or
damage.
WATER LEVEL TUBE
A tube at the rear end of
the saw filters the debris from the
water produced during the cutting
operation. Debris settles in the water
tray while the water is allowed to
pass through the tube and into the
water bucket, where fresh and filtered
water reside.
Remove the water level tube
from the plastic bag.
Inser t the thin end o f the
tube into the rea r hole
nex t to the wate r pump ,
as shown in the illustration.
1.
2.
3. Fill the water
tray with water.