Gundlach 1027 Series, Руководство пользователя, Страница: 14 / 21

PROBLEM POSSIBLE CAUSE
SOLUTION
- Saw blade too hard
-Fixed flange is worn out
- Motor shaft bearing
- Use a softer blade
- Have the fixed flange
replaced
- Replace the bearing
of the motor shaft
Cracks in or near
the diamond
segment
Saw blade is
blunt
Appearance of
cut is not optimal
The center hole
in the saw blade
has become
wider due to
wear
Saw blade shows
blooming colors
Grinding marks
on the saw blade
- Use appropriate type of saw
blade
- Sharpen the diamond saw
blade
- Return the saw blade to the
manufacturer
- Use a suitable saw blade
- Sharpen the saw blade
- The arbor of the saw blade
must be fitted with an
appropriate adaptor ring
- Check the receiving flange
and have it replaced if
necessary
- Ensure an optimum flow of
cooling water
- The material feed is too
high; proceed more slowly
- Ensure that the direction of
feed is absolutely parallel to
the saw blade
- Adjust the roller table/have
it adjusted
- Have the saw blade
tensioned
- The material feed is too
high, proceed more slowly
- Saw blade type is
unsuitable for the material
being cut
- Saw blade type is
unsuitable for the machine
performance
- Diamond segments are
blunt
- Poor tension in the blade
material
- Too much load placed on
the saw blade
- Diamond segments are
blunt
- The saw blade has
slipped on the motor shaft
when running
- Saw blade overheating
due to a lack of cooling
water
- Lateral friction when
cutting
- Material is not being fed
parallel to the saw blade
- Poor tension in the blade
material
- Too much load on the
saw blade
TROUBLESHOOTING NOTES
25 26