GULLCO KBM-18, Список деталей и инструкция по эксплуатации, Страница: 38 / 60

34
It is recommended that the machine be taken out of service once a year, stripped down and all
moving parts be cleaned, lubricated and inspected for wear and damage. All damaged and worn
parts should be replaced.
STORAGE
The KBM
®
-18 Portable Plate Edge Bevelling Machine should be kept in a dry environment with no
possibility of impact or damage due to stacking of objects on top of the equipment.
It is also recommended that due to the susceptibility of the Clamp Roller Hand Wheel and
Revolving Handle to damage, the Clamp Roller Assembly should be removed for storage.
The machine should be stored with a Cutter in place to avoid losing the Cutter Shaft Collar.
When the equipment is brought out of storage, always inspect the condition of the machine prior to
use. Pay particular attention to the condition of the oil.
For storage periods of over 60 days, all machined surfaces should be protected with a suitable anti-
oxidation product.
For storage periods of over 6 months, it is recommended that in addition to the points above, the
gearbox should be filled with extra oil (requiring draining to the correct amount before re-use). It is
also recommended that the rotor be turned every 1 to 2 months and to take adequate measures
against corrosion and humidity.
SHIPPING
When shipping the KBM
®
-18 bevelling machine without the optional undercarriage, lag bolt the
tilting frame to the skid. If the unit is being shipped with the undercarriage, it is recommended that
the machine be secured to a skid that raises the four (4) casters off the floor.
The Clamp Roller Assembly should be removed from the Cutter Shaft Housing to protect it from
damage.
The machine should be shipped with a Cutter in place to avoid losing the Cutter Shaft Collar.
The starter switch assembly should either be removed or protected against damage.