Gude Expert net control 2i2o, Руководство пользователя

Страница: 7 / 14

7
expert net control 2i2o Configuration
4.3.1.1 Label
A name with a maximum of 15 characters can be entered here for each output.
4.3.1.2 After power-up switch
The output’s switching state after a power-on of the device can be defined here (on, off, remember last state).
4.3.1.3 If switching on after power-up, wait ...
While this function is enabled, the output will reactive after the stated time, when it got switched off.
4.3.1.4 After turning off, wait ...
Wenn diese Funktion aktiviert ist, schaltet sich der Output nach einer vorgegebenen Zeit automatisch ein, nachdem er
deaktiviert wurde.
4.3.2 Configuration - IP address
4.3.2.1 Hostname
Enter the host name of expert net control 2i2o. expert net control 2i2o uses this name to connect with DHCP server.
Special signs may destabilize your network.
All changes need a restart of the firmware to get valid.
4.3.2.2 IP Address
Here you can change the IP address of expert net control 2i2o.
All changes need a restart of the firmware to get valid.
4.3.2.3 Netmask
Here you can change the netmask of expert net control 2i2o.
All changes need a restart of the firmware to get valid.
4.3.2.4 Gateway
Here you can change the standard gateway of expert net control 2i2o.
All changes need a restart of the firmware to get valid.
4.3.2.5 Use DHCP
Here you can set, if expert net control 2i2o shall get its TCP/IP settings directly from your DHCP server. If DHCP is
activated, expert net control 2i2o proves if a DHCP server is active inside of your LAN. Then expert net control 2i2o
requests TCP/IP settings from this server. If there is no DHCP server inside of your network, we recommend to deactivate
this function.
All changes need a restart of the firmware to get valid.