QX User Manual – Issue B
- 10
-
Set
Code-02
The system can be partitioned into a number of parts called set groups, each of which can be
individually set. The programmed user authority level must allow setting and the programmed user
area access will determine which set groups are available to a user.
Setting can be started by:
1. A user request on a keypad
2. A user activating a keyswitch
3. Automatically by a timer schedule
4. Remotely from a PC using the Guardall GuardStation software
Setting modes include:
1. Instant, where setting is completed immediately
2. Timed, where setting is completed at the end of the programmed exit time
3. Exit point, where setting is completed by opening and closing the final exit circuit
4. Push button, where setting is completed by pushing the external PB circuits
Your installation engineer should advise which of the above options have been programmed on your
system.
Setting from a keypad
02=Set
04=Test
Workshop
Seconds Left-005
1=Workshop
2=Office
1
0
2
12:00 Mon 27 Sep
Guardall
Workshop
Setting
Workshop
Set
12:00 Mon 27 Sep
Enter- ****
0
2
0
2
✓
Log on set programmed
Log on set programmed, one group available
and no problems or warnings to display
Exit time expired
Log off after set
not programmed
Log off after set
programmed
Easy Set
If easy set mode 1 is programmed then the system will start to part set when you log on. During the
part set exit time, if the exit door circuit is opened and closed, the system will full set. Pressing the
✘
key during the setting time will cancel setting. If easy set mode 2 is programmed then the system
can be set without logging on to a keypad. Up to 8 parts can be set in this way (depends on the
control panel type). For example to set part 1 of your system press 1 +
✔
.
The system can be set by
entering 0 +
✔
.
Intelligent Security & Fire Ltd
