QX User Manual – Issue B
- 13
-
Unset
Code-01
The system will have been partitioned by the installation engineer into a number of set groups. The
user authority will determine the choice of groups, which can be unset. There are several methods of
unsetting available to the user which are discussed in the following section.
Unsetting can be started by:
1. A user request on a keypad
2. A user activating a keyswitch
3. Automatically by a timer schedule
4. Remotely from a PC using the Guardall GuardStation software
Your installation engineer should advise which of the above options have been programmed on your
system.
Unsetting Methods
If a set group incorporates an entry route in the unsetting procedure then opening a final entry door to
the area will start a pre-programmed entry timer. The user must proceed directly to the keypad or
keyswitch via a pre-determined entry route and unset the group as described. If the group is not unset
before the entry time has expired a warning period, equivalent to 50% of the programmed entry time,
will be allowed. This is to warn the user that an alarm condition will occur if the group is not unset by
the end of the warning period. If the group is not unset by the time that the total entry time and
warning time has expired, an alarm condition will be initiated. To comply with the requirements of
DD243 (2002), during the entry time, all alarms in the unsetting area(s) are ignored.
Unsetting from a keypad
Your installer may have set up your system to allow automatic unset when your user code is entered.
The diagram shows the 2 possible unset scenarios when a user logs on to a keypad when area(s) are
set.
01=Unset
04=Test
1=Workshop
2=Office
1
0
12:00 Mon 27 Sep
Guardall
Workshop
Unset
12:00 Mon 27 Sep
Enter- ****
0
2
0
2
✓
Log on unset programmed
1
02=Set
04=Test
Log off after unset programmed
Log off after unset not programmed
Intelligent Security & Fire Ltd
