FST 75/150
260-2210-002 EN064
Page 5 / 37
Safety guidelines
Warning
!
Please read these operating instructions prior to operating the unit for the first time! Ensure that the unit has
dead voltage prior to conducting any installation and maintenance work!
After the unit has been switched
off, there is still a possibility of loaded capacitance carrying dangerous voltage. For this reason, it is
vital that you wait between 3 and 5 minutes to allow the capacitance to discharge! Performing work
on a hot control board can result in death!
The unauthorised opening and improper intervention on the
unit can result in physical injury and damage to property.
To avoid physical injury or significant damage to property, only qualified persons familiar with electrical drive
equipment should be allowed to work on the control unit. Qualified persons are deemed to be those who are
familiar with the setup, installation, initial operation and running of converters and who have the requisite
qualifications for this kind of activity. They must be able to diagnose the tasks they are asked to conduct,
recognise potential sources of risk and take adequate safety measures.
The control unit has been built and tested in accordance with DIN EN 12453 "Safety in use of power-
operated doors - Requirements" and DIN EN 12978 "Safety in use of power-operated doors – Requirements
and testing procedures" and has left the works in fully safe and proper working order. In order to maintain
this order and to ensure that it is operated without risk, the user must observe all of the instructions and
warnings contained in these operating instructions.
The modification or conversion of the
FST 75/150
control unit is only permissible upon prior consultation with
the manufacturer. The operational safety of the supplied
FST 75/150
control unit is only guaranteed if it is
used in the manner prescribed. The limit values given in the technical specifications may not be exceeded
under any circumstances (see relevant sections in the operating instructions).
When using mechanical limit switches the monitoring of standstill, direction of rotation or speed monitoring is
not possible.
Safety regulations
When performing installation work, initial operation, maintenance jobs or testing the control unit, the valid
safety and accident prevention regulations must be observed for the specific case in question. Above all, the
following regulations must be adhered to. At the same time, no warranty is given for the completeness of the
required regulations:
European norms
•
DIN EN 12445
Safety in use of power-operated doors – Testing methods
•
DIN EN 12453
Safety in use of power-operated doors – Requirements
•
DIN EN 12978
Safety in use of power-operated doors – Requirements and test methods
In addition to the above, the normative guidelines of the listed norms must be observed.
•
VDE regulations
•
DIN EN 418
Safety of machinery
EMERGENCY OFF
Set-up, functional aspects, design guidelines
•
DIN EN 60204-1
VDE 0113-1
Electrical equipment with electric accessories
•
DIN EN 60335-1
VDE 0700-1
Safety of household and similar appliances
•
BGV A2
employer's liability insurance association
regulations for health and safety
•
ZH1/494
Guidelines for power-operated windows, doors and gates.
•
Fire prevention regulations
•
Accident prevention regulations
