GTE CoboSafe-Scan, Руководство по эксплуатации

Страница: 10 / 28

FOR yOUR SAFETy
10 CoboSafe-Scan 325-2810-013US13
2.4 Residual Risk When Using CoboSafe-CBSF Force Sensors
Please read the chapter "Residual risks" in the corresponding document

"CoboSafe – General
safety instructions".
Attention!
The measurement setup must meet requirements with regard to stiffness and at the
same time guarantee stability. Therefore, hard and stiff components must be used,
which must be firmly connected to each other. Depending on the measurement
setup, burrs, corners and edges can cause cut and impact injuries, for example
when using aluminum profiles. Falling or tilting components of the measuring setup
can cause injuries.
GEFAHR WARNING
Dangerous measurement setup
Risk of injury due to improperly erected measurement setup!
■
Establish measurement setup only with deburred compo-
nents.
■
Upholster corners and edges.
■ Secure measurement setup against unauthorized access.
■ Wear specified protective equipment.
■
Secure the measurement setup against tilting.
If the measurement setup is established using sharp ed-
ged components or has sharp corners, this can result in
cuts and impact injuries. Tilting parts of the measurement
setup (e.g., due to low stability) can cause impact and
crushing injuries.
GEFAHR WARNING
Falling components
Risk of injury from dropping or dropping components!
■
Keep order in the workplace.
■
Keep work surfaces free for assembly and storage of
components.
■
After use, store unused components as described in this
manual.
■
Handle all components with care.
■
Always hold the force sensors at the side for lifting and
positioning and make sure that the display and switch are
not touched.
■ Wear specified personal protective equipment.
Some components of the measuring system are heavy
and hard. If force sensors, mounting adapters, transport
cases, film rolls or the scanner are dropped, severe inju -
ries up to crushing and bone fractures can result.