Page 13
Installation
Before starting the installation consider
Which power option is to be used - as this may influence cabling requirements, vicinity to power outlets
and accessory modules required (refer to Power Options for GT8)
Fitting the Terminal
Location:
The Terminal should be fixed to a flat surface at a height that is comfortable for users to view and interact
with the screen without glare from reflections and in a suitable level of ambient light. Take care to adhere to
any local regulations such as disabled access when determining the height of the unit.
Fitting GT8 to Wall Bracket
1.
Remove wall bracket securing screw to release
wall bracket from GT8.
2.
With the wall bracket against the wall, mark the 4
screw mount fixing points (C) and the preferred
cable routing position.
3.
Drill holes in the wall and mount the wall bracket
with screws taking care to feed the cables
through the bracket aperture.
4.
Offer the GT8 unit close to the wall bracket and
connect Ethernet and/or power cables.
5.
Position the GT8 unit slightly above the wall
bracket with its back parallel with the wall and
make sure all cables are free to move.
6.
Centralise the GT8 unit against the wall bracket
and slowly lower the terminal by sliding it down
the wall until metal tangs ‘A’ engage into slots ‘B’.
7.
With the terminal fully down until it stops against
the wall bracket re-fit the M4 screw in the base
making sure to press the lower portion of the
terminal into the wall to make sure it sits snug
against the wall.
VESA Mounting Points
A
A
B
B
Optical Tamper
Reflective Strip
Do not remove!
C
C
C
C
For optimum fixing
we recommend using
the outer wall plate
mounting holes ‘C’.
D
Cable Apertures
For ease of cable routing we recommend using
the lower (larger) aperture where possible.
When running cables from underneath, please
remove the blanking plate ‘D’ from the GT8.
Wall Bracket
Securing Screw