158
PART 2
Applying Frame Protection
138692 Rev 0 (04/22)
Section F.
GT Bicycle Owner’s Manual
3. Rub the guard firmly against the frame with
your fingers to fix it in place.
4. Periodically, recheck the guards and other
areas of the frame as you continue to ride.
Replace the guards if they wear out.
Also, adhesive frame guards are not a fix for
incorrectly installed or routed cables or lines. If
you find that applied guards are wearing out
very quickly, consult with your Authorized GT
Dealer about the routing on your bike.
Figure 25.
This photo shows a typical use of guard material
at a contact point.
•
Headtube area
•
Seattube
•
Pivots areas
•
Anywhere a control cable or housing may
contact the frame.
Applying Frame Protection
Some areas of your bicycle require protection
from abrasion. If protection is not in place,
damage can result. Please consult with your
Authorized GT Dealer about the replacement
location and position of these various frame
protections.
NOTE: Damage to your bike resulting cable rub is
not covered under your warranty. Make sure
the protections indicated below are in place
whenever you ride your bike. Ask your
Authorized GT Dealer for help.
Housing and Cable Guides
Normal line and cable movement against the
frame can wear away painted finishes and
decals.
Figure 23.
To apply the guard material:
1. Clean the frame with a mild detergent and
wipe dry with a clean towel. Do not use
solvents or harsh chemicals to clean the
frame. OPTIONAL: Trim the adhesive guard
material to the shape required.
2. Remove the backing and position the guard
under the cable/ line.
Содержание Grade
Страница 171: ...171 PART 3 STEP 6 Installing the Handlebar And Stem Assembling Your Bike GT Bicycle Owner s Manual A B...
Страница 192: ...192 PART 3 D Through Axle Pinch bolt Type 138692 Rev 0 04 22 8 Install Front Wheel GT Bicycle Owner s Manual...
Страница 193: ...193 PART 3 D Through Axle Pinch bolt Type 8 Install Front Wheel GT Bicycle Owner s Manual...
Страница 219: ......