GT POWER GT4000ESi, Руководство по эксплуатации

Страница: 15 / 32

15.
Only use gasoline that meets the following require-
ments:
• Unleaded gasoline only
• Gasoline with maximum 10% ethanol added
• Gasoline with an 87 octane rating or higher
Follow the steps below to fill the fuel tank:
1. Shut off the generator.
2. Allow the generator to cool down so all surface
areas of the muffler and engine are cool to the
touch.
3. Move the generator to a flat surface.
4. Clean area around the fuel cap.
5. Remove the fuel cap by rotating counterclockwise.
Figure 5: Maximum Gasoline Fill Level
NOTE: Do not overfill the fuel tank. Spilled fuel will
damage some plastic parts.
6. Slowly add gasoline into the fuel tank. Be very
careful not to overfill the tank. The gasoline level
should NOT be higher than the red ring (see Figure
5).
7. Install the fuel cap by rotating clockwise.
Starting the Generator
NOTE: before starting the inverter, review safety
section in this manual.
For proper starting and operation of the inverter, make
sure you review the inverter features and their
descriptions starting on page 8.
DANGER!
Never use the generator in a location that is wet
or damp. Never expose the generator to rain,
snow, water spray or standing water while in use.
Protect the generator from all hazardous weather
conditions. Moisture or ice can cause a short
circuit or other malfunction in the electrical
circuit.
Never operate in an enclosed area. Engine
exhaust contains carbon monoxide. Only
operate the inverter outside and away from
windows, doors and vents.
Electric Start
1. Check oil levels (see Adding Engine Oil on page 14)
2. Make sure nothing is plugged into any of the
outlets.
3. Make sure battery is connected (see Installing the
Battery on page 14).
5. Turn the Fuel
Control Switch
to the ON
position
(see Figure 6).
Figure 6: Turn Fuel Switch to ON Position
Before attempting to start the generator, verify the
following:
• The engine is filled with engine oil (see Figure 4:
Engine Oil Correct Level on page 14).
• The generator is situated in a proper location (see
Location Selection on page 13).
• The generator is on a dry surface (see Weather and
Dry Surface on page 13).
• All loads are disconnected from the generator (see
No Connected Loads on page 13).
• The generator is properly grounded (see Grounding
the generator on page 13)
4. Make sure the circuit breakers are properly set.
www.gtpower.co.nz