GT POWER GT4000ESi, Руководство по эксплуатации

Страница: 14 / 32

14.
WARNING!
Do not operate a device while it is plugged into
the 12V DC outlet. Prolonged exposure to engine
exhaust can cause serious injury or death. While
charging a device do no place on the exhaust
side of the generator. Extreme heat caused by
exhaust can damage the device, and cause a
potential fire hazard.
Adding Engine Oil
The unit as shipped does not contain oil in the
engine. You must add engine oil before starting for
the first time.
NOTE: Attempting to start the engine without adding
engine oil will permanently damage internal engine
components.
The engine is equipped with a low oil shutdown
switch. If the oil level becomes low, the engine may
shut down and not start until the oil is filled to the
proper level.
The owner of the generator is responsible to ensure
the proper oil level is maintained during the operation
of the generator. Failure to maintain the proper oil
level can result in engine damage.
1. Unclip and remove the oil service panel to access
the oil fill/drain plug (see Figure 3).
Figure 3: Oil Service Panel
2. Clean area around oil fill/drain plug and remove
plug.
Oil Filter Cap (Dipstick)
Upper Level
Lower Level
Figure 4: Engine Oil Levels
4. Do not overfill, if oil level is too high, oil will drain
out through the fill plug.
DANGER!
Filling the fuel tank with gasoline while the
generator is running can cause gasoline to leak
and come in contact with hot surfaces that can
ignite the gasoline.
CAUTION!
Avoid prolonged skin contact with gasoline.
Avoid prolonged breathing of gasoline vapors.
Adding Fuel
NOTE: Before adding engine oil, review safety section
earlier in this manual.
Engine oil must be added when the generator is on a
flat, level surface, or an inaccurate reading may result.
Do not overfill. If the engine is overfilled with oil, it can
cause serious engine damage.
Only use the engine oil specified in diagram below.
Only use 4-stroke/cycle engine oil. NEVER USE
2-STROKE/CYCLE OIL. Synthetic oil is an acceptable
substitute for conventional oil.
3. Using the supplied funnel and oil, pour the entire
bottle of oil into the engine. See correct oil level in
Figure 4 below.
www.gtpower.co.nz