GT POWER GT4000ESi, Руководство по эксплуатации

Страница: 17 / 32

17.
Normal Operation
During normal operation, use the following steps to
stop your machine.
1. Remove any connected loads from the control
panel receptacles.
2. Allow the generator to run at “no load” to reduce
and stabilize engine and alternator temperatures.
3. Move the Fuel Control Switch to the OFF position,
press “Stop” on remote start key fob, or press the
push button start once (see Figure 10).
Stopping the
Generator
Figure 10: Stopping Generator
START
STOP
During an Emergency
If there is an emergency and the generator must be
stopped quickly, move the Fuel Control Switch to the
OFF position immediately.
Using Efficiency Mode
The generator is equipped with an efficiency mode
switch to minimize fuel consumption. In efficiency
mode, the generator will sense the load and adjust
the engine RPM to the current load requirements.
Efficiency mode should be used only after the genera-
tor has been warmed up to operating temperature.
1. To turn on the efficiency mode, press the switch to
the ON position).
3. As a load is applied, the generator will sense the
load and engine RPM will increase according to the
load applied.
4. To run the generator at maximum power and RPM,
press the efficiency mode switch to the OFF
position.
Resetting the Reset Breaker
The generator will trip the breaker and automatically
disconnect from the load when the controls sense a
predetermined overload condition. The generator
engine will continue to run, but there will not be any
electrical output.
1. Turn off all devices and unplug them from the
generator.
2. Determine the wattage required from the devices
being powered by the generator. Make sure the
wattage required does not exceed the maximum
output of the generator.
3. Press in the reset breaker to reset it.
4. Plug the devices in to the generator.
5. Turn on the devices as needed.
www.gtpower.co.nz
2. If no load is present, the generator RPM will drop
down to an idle speed.